Fine Audio Instruments ECP1 MM 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Fine Audio Instruments ECP1 MM에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fine Audio Instruments ECP1 MM 6 페이지. Phono preamplifier

Connecting ECP1 Phono preamplifier

Connecting to mains

Check that the mains voltage printed on the AC adapter corresponds with the line voltage in

the territory were you intend to connect your preamplifier.

The rear panel

The rear panel of the ECP1 contains all input- and output connectors. The printed rear panel

clearly indicates the function of each connector.

How to avoid noise problems

The ECP1 preamplifier contains circuitry that might be sensitive to magnetic fields. The set

should be placed well away from transformers, etc. Care should also be taken in routing all

signal cables. They should not run parallel to speaker cables or AC cables mains). Keep

cables as short as possible. For minimum hum, the preamplifier should be places on the right

side of the power amplifier because of the location of the MC circuitry). If placed above a

power amplifier, leave at least 4" 110 cm) of space between the top of the amplifier and

bottom of the preamplifier.

How to avoid damages

A good operating practice is to turn off all equipment before any connection or disconnection

are made. Do not under any circumstances connect or disconnect equipment when power is

turned on. If you insist on connecting or disconnecting while power is turned on, you should

be aware that the design of the RCA plug generates a large transient when inserting the plug.

This could damage both the speakers and the amplifier.

Switches

The MC/MM switch is located at the rear of the unit, and LED in the frontpanel indicate the

selected type of cartridge.

ALWAYS turn the volume control all the way down before changing from MM/MC or

MC/MM.