Cisco ASR 9000 Series 구성 매뉴얼 - 페이지 20
{카테고리_이름} Cisco ASR 9000 Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 9000 Series 50 페이지. Line card
Cisco ASR 9000 Series에 대해서도 마찬가지입니다: 네트워크 설정 구성 (26 페이지), 구성 매뉴얼 (46 페이지), 매뉴얼 (24 페이지), 구성 (46 페이지), 매뉴얼 (44 페이지), 빠른 참조 매뉴얼 (7 페이지)
페이지 인쇄
How to Configure Serial Interfaces
Command or Action
Step 10
show ipv4 interface brief
Example:
RP/0/0RP0RSP0/CPU0:router # show ipv4 interface
brief
Step 11
show interfaces serial interface-path-id
Example:
RP/0/0RP0RSP0/CPU0:router# show interfaces
serial 0/1/0/0
What to Do Next
To modify the default configuration of the serial interface you just brought up, see the
Optional Serial Interface Parameters" section on page
Configuring Optional Serial Interface Parameters
This task describes the commands used to modify the default configuration on a serial interface.
Prerequisites
Before you modify the default serial interface configuration, you must bring up the serial interface and
remove the shutdown configuration, as described in the
page
Restrictions
The configuration on both ends of the serial connection must match for the interface to be active.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
518
514.
configure
interface serial interface-path-id
encapsulation [hdlc | ppp | frame-relay [IETF]
serial
crc length
invert
scramble
transmit-delay hdlc-flags
end
or
commit
exit
Configuring Serial Interfaces on the Cisco ASR 9000 Series Router
Purpose
Verifies that the interface is active and properly configured.
If you have brought up a serial interface properly, the
"Status" field for that interface in the show ipv4 interface
brief command output displays "Up."
(Optional) Displays the interface configuration.
518.
"Bringing Up a Serial Interface" section on
"Configuring
OL-26061-03