Cisco ASR 9000 Series 구성 매뉴얼 - 페이지 30

{카테고리_이름} Cisco ASR 9000 Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 9000 Series 50 페이지. Line card
Cisco ASR 9000 Series에 대해서도 마찬가지입니다: 네트워크 설정 구성 (26 페이지), 구성 매뉴얼 (46 페이지), 매뉴얼 (24 페이지), 구성 (46 페이지), 매뉴얼 (44 페이지), 빠른 참조 매뉴얼 (7 페이지)

페이지 인쇄
Cisco ASR 9000 Series 구성 매뉴얼
How to Configure Serial Interfaces
Command or Action
Step 3
keepalive {seconds | disable}
or
no keepalive
Example:
RP/0/0RP0RSP0/CPU0:router(config-if)# keepalive
3
or
RP/0/0RP0RSP0/CPU0:router(config-if)# no
keepalive
Step 4
end
or
commit
Example:
RP/0/0RP0RSP0/CPU0:router(config-if)# end
or
RP/0/0RP0RSP0/CPU0:router(config-if)# commit
Step 5
show interfaces serial interface-path-id
Example:
RP/0/0RP0RSP0/CPU0:router# show interfaces
serial 0/1/0/0
How to Configure a Layer 2 Attachment Circuit
The Layer 2 AC configuration tasks are described in the following procedures:
•
•
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
528
Creating a Serial Layer 2 Subinterface with a PVC
Configuring Optional Serial Layer 2 PVC Parameters
Configuring Serial Interfaces on the Cisco ASR 9000 Series Router
Purpose
Specifies the number of seconds between keepalive
messages.
•
Use the keepalive disable command, the no keepalive,
or the keepalive command with an argument of 0 to
disable the keepalive feature.
The range is from 1 to 30 seconds. The default is 10
•
seconds.
If keepalives are configured on an interface, use the no
•
keepalive command to disable the keepalive feature
before configuring Frame Relay encapsulation on that
interface.
Saves configuration changes.
When you issue the end command, the system prompts
•
you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
Entering yes saves configuration changes to the
–
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
Entering no exits the configuration session and
–
returns the router to EXEC mode without
committing the configuration changes.
Entering cancel leaves the router in the current
–
configuration session without exiting or
committing the configuration changes.
Use the commit command to save the configuration
•
changes to the running configuration file and remain
within the configuration session.
(Optional) Verifies the interface configuration.
OL-26061-03