Cisco ASR 9000 Series 구성 매뉴얼 - 페이지 44
{카테고리_이름} Cisco ASR 9000 Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 9000 Series 50 페이지. Line card
Cisco ASR 9000 Series에 대해서도 마찬가지입니다: 네트워크 설정 구성 (26 페이지), 구성 매뉴얼 (46 페이지), 매뉴얼 (24 페이지), 구성 (46 페이지), 매뉴얼 (44 페이지), 빠른 참조 매뉴얼 (7 페이지)
페이지 인쇄
Configuration Examples for Serial Interfaces
Command or Action
Step 5
service policy output service-policy-name
Example:
RP/0/0RSP0/CPU0:router(config-if)# service policy
input | output | type service-policy-name
Step 6
end
or
commit
Example:
RP/0/0RSP0/CPU0:router(config-if)# end
or
RP/0/0RSP0/CPU0:router(config-if)# commit
Configuration Examples for Serial Interfaces
This section provides the following configuration examples:
•
•
•
•
Bringing Up and Configuring a Serial Interface with Cisco HDLC Encapsulation:
Example
The following example shows how to bring up a basic serial interface with Cisco HDLC encapsulation:
RP/0/0RP0RSP0/CPU0:Router#config
RP/0/0RP0RSP0/CPU0:Router(config)# interface serial 0/3/0/0/0:0
RP/0/0RP0RSP0/CPU0:Router(config-if)# ipv4 address 192.0.2.2 255.255.255.252
RP/0/0RP0RSP0/CPU0:Router(config-if)# no shutdown
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
542
Bringing Up and Configuring a Serial Interface with Cisco HDLC Encapsulation: Example,
page 542
Configuring a Serial Interface with Frame Relay Encapsulation: Example, page 543
Configuring a Serial Interface with PPP Encapsulation: Example, page 545
IPHC Configuration: Examples, page 545
Configuring Serial Interfaces on the Cisco ASR 9000 Series Router
Purpose
(Optional) Specifies the name of the QoS service
policy to which the IPHC profile applies. Only output
service policies are allowed.
Used only when mode service-policy is specified in
Step
2.
Saves configuration changes.
When you issue the end command, the system
•
prompts you to commit changes:
Uncommitted changes found, commit them
before exiting (yes/no/cancel)?
[cancel]:
Entering yes saves configuration changes to
–
the running configuration file, exits the
configuration session, and returns the router
to EXEC mode.
–
Entering no exits the configuration session
and returns the router to EXEC mode without
committing the configuration changes.
Entering cancel leaves the router in the
–
current configuration session without exiting
or committing the configuration changes.
Use the commit command to save the
•
configuration changes to the running
configuration file and remain within the
configuration session.
OL-26061-03