Cisco Connected Life CLG-8202-WW 설치 매뉴얼 - 페이지 2

{카테고리_이름} Cisco Connected Life CLG-8202-WW에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Connected Life CLG-8202-WW 2 페이지.

페이지 인쇄

What's in the carton?

Verify that the following items are in the shipping carton. If any items

are missing, contact your service provider:

• The CLG-8202-WW Connected Life Gateway

• The CLG-8202-WW Connected Life Gateway cradle

• Protective cover for the USB connector

• AC power adapter

• Yellow CAT 5 Ethernet cable

• Two Phillips screws

Installation instructions

The gateway can be installed in one of two ways: desktop- or wall-

mounted.

Items needed

In addition to the items provided in the gateway shipping carton, the

following additional materials are needed:

• One Phillips screwdriver

• One Ethernet cable long enough to reach from the Cisco

Connected Life Gateway to a PC or router

When mounting to a wall, the following additional materials are

needed:

• One pencil to trace the mounting holes to the wall

• Two #6 (M3.5) pan head screws

• One screwdriver

• One drill and drill bit

Wall mounting

Mounting holes

1. Turn the cradle so the mounting holes are opposite from you,

and place the cradle against the wall where you intend to mount

it.

2. While holding the cradle in place, use a pencil to trace the

mounting holes onto the wall.

3. Drill two holes into the wall where the pencil traces indicate.

4. Install the mounting screws into the wall, leaving a gap of about

½-inch between the screw head and the wall.

5. Place the cradle into position by slipping the large end of both

mounting slots over the screw heads and sliding the cradle

down until the narrow end of the mounting slots contacts the

screw shafts.

6. Continue installing the gateway by following the instructions for

Desktop mounting.

Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affi liates in the U.S. and other countries. To view a list of Cisco trademarks, go to

this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a

partnership relationship between Cisco and any other company. (1110R)

Printed in China

Desktop mounting

Allow approximately 3-5 minutes to install the gateway to stand on a

desktop.

Controller

Cradle

1. Insert the gateway into the cradle until you feel it lock into place.

2. Using a screwdriver, secure the controller to the cradle by

inserting the two screws and tightening.

3. Insert one end of an Ethernet cable into the yellow Internet port

and the other end of the cable into an Ethernet port on a router.

Note: The gateway will be connected to a router except during

initial set up when it is connected to a PC for confi guration of

network parameters.

4. Insert one end of the AC power adapter cable into the Power

port and the other end of the cable into a power outlet.

5. Turn the Power switch to the on position (|). All LEDs will fl ash

for one second; during this time, the STATUS LED will fl ash red,

yellow, and green.

Battery replacement

The gateway internal real time clock battery is designed to last up to

nine years under normal operating conditions. Should the battery fail

before that time, contact your service provider for assistance. Do not

attempt to replace the battery on your own; doing so could damage

the gateway.

Open Source License Statement

Cisco Connected Life Gateways may contain, in part, certain free

and/or open source software ("Open Source") under separate

license terms. Examples of such licenses may include all versions

of the GNU General Public License (GPL), GNU Lesser General

Public License (LGPL), BSD license, MIT license, Mozilla Public

License, Eclipse Public License, Apache license, and others. To fi nd

specifi c information regarding the Open Source in your product,

including copies of the applicable license documentation and related

information, go to: (i) for North America

web/consumer/support/open_source.html, or (ii) for outside North

America

http://www.cisco.com/web/consumer/support/open_

source.htm#~international. Once at the site, search for the product

listing and click the related items identifi ed. If you have any questions

or problems accessing any of the links, contact:

[email protected].

Last Updated: July 2014

Phillips

Screws

http://www.cisco.com/

spvtg-external-

Part Number: 78-100422-01A0