Cisco DPC3848 사용자 설명서 - 페이지 33

{카테고리_이름} Cisco DPC3848에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco DPC3848 50 페이지. Cogeco wireless internet modem
Cisco DPC3848에 대해서도 마찬가지입니다: 매뉴얼 (35 페이지), 설치 및 활성화 지침 (2 페이지)

페이지 인쇄

Locate the AC power cord provided with your residential gateway. Connect the

barrel connector end of the power cord into the power input on the back of the

residential gateway. Then, plug the other end of the power cord into an AC

outlet.

The residential gateway will perform an automatic search to locate and sign on

to the broadband data network. This process may take up to 2-5 minutes. The

residential gateway will be ready for use when the Power, US/DS, and Online

LEDs on the front panel of the residential gateway stop blinking and remain on

continuously.

Plug in and power on your PC and other home network devices. If one or more

of these devices uses wireless networking, the 2.4G or 5G LED on the residential

gateway should be on or blinking.

At this point, the installation is complete, and you can begin surfing the Internet.

Note: If your PC does not have Internet access, refer to How Do I Configure

TCP/IP Protocol? (on page 26) for information on how to configure your PC for

TCP/IP. For Internet devices other than PCs, refer to the DHCP or IP Address

configuration section of the User Guide or Operations Manual for those devices.

OL-30 544 -01

Install the Wireless Residential Gateway