Cisco Expressway CE1000 Appliance 설치 매뉴얼 - 페이지 6

{카테고리_이름} Cisco Expressway CE1000 Appliance에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Expressway CE1000 Appliance 16 페이지. X8.2 or later

Installing

See

http://www.cisco.com/en/US/docs/unified_computing/ucs/c/hw/C220/install/install.html#wp1341126

for information on how to install the unit in a rack.

The CE1000 unit is shipped with two 10 Gb fiber small form-factor pluggable (SFP) transceivers and two 1

Gb copper SFPs. When inserting the SFPs into the unit, note that you cannot mix the type of SFP. Either

insert two 10 Gb fiber SFPs or two 1 Gb copper SFPs.

The SFPs do not auto-negotiate the speed, therefore ensure that the SFPs are connected to a switch at the

correct speed (1 Gb if connecting to the copper SFPs or 10 Gb if connecting to the fiber SFPs)

Note: you must install the 10 Gb fiber SFPs to take advantage of the unit's performance and scalability

capabilities, otherwise it will not support more than 150 traversal calls. This is the case even if the option key

for additional traversal calls has been installed.

Attach a power cord to each power supply in your server, and then attach the power cord to a grounded AC

power outlet. See

http://www.cisco.com/en/US/docs/unified_

computing/ucs/c/hw/C220/install/spec.html#wp1070378

The power button of the unit is located in the top left-hand corner of the front panel.

If this is the first time that the power switch has been turned on after connecting the power cable, the system

will perform a Self Test and the unit will automatically restart. This is expected behavior. The system will be

operational after it has booted up a second time. The first boot will take approximately 2 minutes.

To verify the power status look at the Power Status LED (see

unit.

[p.12]):

Off—There is no AC power present in the server.

Amber—The server is in standby power mode. Power is supplied only to the CIMC and some motherboard

functions.

Green—The server is in main power mode. Power is supplied to all server components.

Cisco Expressway CE1000 Appliance Installation Guide (8.5)

for power specifications.

Figure 3: Front view of the Cisco Expressway

Page 6 of 16