Cisco Expressway CE1200 설치 매뉴얼 - 페이지 17
{카테고리_이름} Cisco Expressway CE1200에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Expressway CE1200 23 페이지.
Cisco Expressway CE1200에 대해서도 마찬가지입니다: 어플라이언스 설치 매뉴얼 (42 페이지)
Cisco Expressway CE1200 Appliance Installation Guide
Run the Install Wizard
Run the Install Wizard
After the system boots up the terminal emulator program on the PC displays Cisco Expressway startup information.
After approximately four minutes the Install Wizard is displayed.
If the Cisco Expressway was already on when you connected and you don't see the Install Wizard, press Ctrl+D to
access it. If you encounter issues or enter incorrect information during the wizard you can press Ctrl+D to restart it.
Install Wizard Process
1.
Follow the prompts in the Install Wizard to specify the following:
IPv4, IPv6, or both.
—
LAN 1 IPv4 subnet mask of the Cisco Expressway (if you select IPv4).
—
IP address of the Expressway default gateway.
—
Password for root user account.
—
Password for admin user account.
—
Whether to enable the Expressway web UI (recommended).
—
If you plan to deploy the appliance as an Expressway-E then you must enable the web UI. It's not possible to
configure the appliance as an Expressway-E through the CLI.
Whether to allow SSH access to the Cisco Expressway CLI.
—
Timezone. The default is UTC. You can search and replace with your desired zone in the wizard. Or you can
—
change it later through the System > Time page in the web user interface.
2.
Wait for the wizard to finish and the Installation wizard complete message to appear.
3.
Press Enter to continue.
4.
The system applies the specified settings and reboots.
5.
After the reboot completes, the Expressway is ready to use.
Note:
The system services restart after you complete the wizard. This is expected behavior.
You can now access the Expressway user interface using the IP address assigned to the LAN1 Ethernet port (see
next section).
17