Cisco Expressway CE1200 어플라이언스 설치 매뉴얼 - 페이지 37

{카테고리_이름} Cisco Expressway CE1200에 대한 어플라이언스 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Expressway CE1200 42 페이지.
Cisco Expressway CE1200에 대해서도 마찬가지입니다: 설치 매뉴얼 (23 페이지)

페이지 인쇄

Troubleshooting

•

Locating LEDs and Components

The panel layouts for this appliance are described in:

•

Definitions of LED States

The various LED states are defined in the Cisco UCS C220 M5 Server Installation and Service Guide at

https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/hw/C220M5/install/C220M5.html

Reset from the Internal Recovery Partition (IRP)

The Cisco Expressway CE1200 appliance comes pre-installed with an SD card that you can use to complete

a reinstall of your configuration. You must reset the SD card and enable the virtual drive before proceeding

with the reinstall using the KVM console in the Cisco Integrated Management Controller (CIMC). Once the

reset is complete, make sure that you disable the virtual drive again.

Before you begin

You need to set up and access the CIMC, as described in

Task 1: Reset the SD Card and Enable the Virtual Drive

Step 1

Locating LEDs and Components, on page 31

Definitions of LED States, on page 31

Reset from the Internal Recovery Partition (IRP), on page 31

Lag During Boot up Due to Power Characterization Check, on page 33

Front Panel Layout

Rear Panel Layout

A P P E N D I X

Run the Install

Cisco Expressway CE1200 Appliance Installation Guide (14.0)

Wizard.