Cisco Firepower 1600 하드웨어 설치 매뉴얼 - 페이지 15

{카테고리_이름} Cisco Firepower 1600에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 1600 44 페이지.

페이지 인쇄
Cisco Firepower 1600 하드웨어 설치 매뉴얼
Overview
7
9
11
13

Rear Panel LEDs

The following figure shows the rear panel LEDs and describes their states.
Figure 9: Rear Panel LEDs and Their States
1
Serial console port (RJ-45 connector)
Disabled by default; use the VGA port
and keyboard USB port instead. See
the "Set up Serial Access" topic in the
Cisco Firepower Management Center
Getting Started Guide for Models
1600, 2600, and
4600.
770-W AC power supply (PSU 1)
Threaded holes for dual-hole
grounding lug
eth3 management interface
10-Gigabit Ethernet SFP+ support
Use only Cisco-supported SFP+
transceivers.
100-Mbps/1-Gbps/10-Gbps Ethernet
link (speed on both LAN1 and LAN2):
• Off—Link speed is 100 Mbps.
• Amber—Link speed is 1 Gbps.
• Green—Link speed is 10 Gbps.
Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide
8
Unit identification button
10
770-W AC power supply (PSU 2)
12
eth2 management interface
10-Gigabit Ethernet SFP+ support
Use only Cisco-supported SFP+
transceivers.
14
Riser handle
Not in use
2
100-Mbps/1-Gbps/10-Gbps Ethernet
link status (speed on both LAN1 and
LAN2):
• Off—No link is present.
• Green—Link is active.
• Green, flashing—Traffic is
present on the active link.
Rear Panel LEDs
11