Epson Perfection 4870 Pro 여기에서 시작하기 매뉴얼 - 페이지 4
{카테고리_이름} Epson Perfection 4870 Pro에 대한 여기에서 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Perfection 4870 Pro 8 페이지. B11b163071
Epson Perfection 4870 Pro에 대해서도 마찬가지입니다: 브로셔 및 사양 (5 페이지)
페이지 인쇄
7
Follow the on-screen instructions to install the software. If you are prompted
to restart, click Quit.
8
At the end of the installation, click Exit.
9
Register your scanner when prompted, then remove the CD-ROM.
Install LaserSoft SilverFast, MonacoEZcolor, and the ArcSoft Software Suite,
following the instructions included with each program.
Then follow the instructions in section 3 to connect the scanner.
Connect the Scanner
After your software is installed, it's time to connect your scanner.
1
Remove the sticker from the transportation lock. Use a coin to turn the lock
clockwise one-quarter turn to unlock the scanner carriage.
2
Remove the sticker from the back of the scanner.
Remove
sticker
3
Connect the cable for the built-in transparency unit (scanner cover). Make
sure the notch and arrow on the connector are facing up.
4
Connect either the USB cable that came with the scanner or an optional
IEEE 1394 (FireWire) cable. Do not connect both cables.
If you're using USB
Plug the square end of the USB cable into the scanner's USB port. Then
plug the flat end into any available USB port on your computer or hub.
Note: Your scanner may not work correctly if you use a USB cable other
than the one supplied by EPSON or if you connect your scanner through
more than one hub.
Turn over