Epson Perfection 4990 사용자 설명서 - 페이지 23

{카테고리_이름} Epson Perfection 4990에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Perfection 4990 30 페이지. Scanning application force quits on mac os 10.4
Epson Perfection 4990에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (9 페이지), 여기에서 시작하기 매뉴얼 (8 페이지), 제품 정보 매뉴얼 (6 페이지), 제품 지원 게시판 (23 페이지), 제품 지원 게시판 (40 페이지), 제품 지원 게시판 (24 페이지), 제품 지원 게시판 (29 페이지), 제품 지원 게시판 (8 페이지), 제품 지원 게시판 (3 페이지), 제품 지원 게시판 (14 페이지), 제품 지원 게시판 (12 페이지), 제품 지원 게시판 (40 페이지), 제품 지원 게시판 (11 페이지), 제품 지원 게시판 (40 페이지), 제품 지원 게시판 (22 페이지), 제품 지원 게시판 (12 페이지), 제품 지원 게시판 (21 페이지), 매뉴얼 (16 페이지)

User's Manual

The TWAIN drivers for various scanners were listed in Table 2. Possible causes of Scan Failed

error message include but are not limited to the following:

• not placing an original on the document table

• manually cancelling a scan (while not the preferred method, it is possible to cancel a scan

during the preview: on the screen shown in Figure 12, push

shown in Figure 15, push

• scanner power turned off (difficult to do on the V3 Cart)

• a scanner cable has been disconnected (cables are well protected on the V3 Cart)

• an actual malfunction of the scanner (the indicator light will flash red)

• the TWAIN driver does not match the scanner model (the TWAIN driver is selected and

tested by qualified personnel when the scanner is installed)

Users may be able to clear this message as follows:

1. click the

button to view the list of drivers

Yes

2. click

to accept the highlighted driver (the correct driver should be established when the

system is installed and should not need to be changed)

3. click the

Scan

If the problem persists, contact AFHCAN Customer Support at 888-449-4435.

1.2 Particulars of the AFHCAN Installation

On the V3 Cart the scanner is in the second drawer (Figure 19). This limits access to the power

switch, the cables, and the scanner transport locks. The scanner power switch is normally left on

with power to the scanner being controlled via the Cart's main power switch.

The use of equipment options such as a sheet feeder or separate transparency unit are not

supported in the AFHCAN installation.

The front panel buttons on the scanners do not interact with the AFHCAN software.

The position of the scanner in the drawer does not permit the scanner cover to be opened to the

full 90 degree position. As installed in the second drawer on the V3 Cart, the Model 4490 cover

opens to the first detent (about 45 degrees). Scanner covers should not be removed.

PUB-119 Rev B.doc

Scanner

)

Scan Color

button

Cancel

Epson Perfection

, then on the screen