Cisco IR510 하드웨어 설치 매뉴얼 - 페이지 25
{카테고리_이름} Cisco IR510에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco IR510 28 페이지. Wpan gateway and wpan range extender
페이지 인쇄IR510 WPAN Gateway and IR530 WPAN Range Extender Hardware Installation Guide
IR530 Series Resilient Mesh Range Extender Installation
Use a plug that complies with local and national electrical codes.
Verify the connection between the cable and plug is weatherproof.
Note: You might have to cut the cable if a specific cable length is needed for your installation.
CAUTION: Ensure that the power source is OFF before connecting or disconnecting the power cord wires from the power source.
CAUTION: To attach the appropriate connector the AC power cable, follow the manual or other instructions provided by the electrical
equipment vendor, ensuring that you comply with the electrical codes for your installation location.
Figure 15
IR530 Range Extender Connector
Notch
Table 14
Pin
1
2
3
Connecting to AC Power
To connect the IR530 Range Extender power connector in to an AC power source:
1.
Always connect the IR530 Range Extender end of the cable first. When removing the AC power connector, always disconnect the
IR530 Range Extender end of the cable last.
2.
Verify that the unit is grounded as described in the "Grounding the WPAN Range Extender" section on page 2-24.
3.
Turn off power to the AC power source at the designated circuits.
4.
Align the notch in the IR530 Range Extender power cable connector with the key in the range extender AC power connector, and push
the cable connector into the range extender connector. When the cable connector is fully seated, rotate the cable connector ring
clockwise until it is hand-tightened to a torque of 6-7 ft-lbs (8.13-9.49 N-m).
5.
Confirm the WPAN antennas are connected to the range extender before you apply power to the range extender.
6.
Connect the other end of the AC power cable to the power source, using the instructions that came with the connecting device.
7.
Turn on AC power at the designated circuits. The range extender will power on and boot the software image.
Signal Name
L
N
Chassis
25
Signal Description
AC line
AC neutral
Chassis ground