Cisco IR530 하드웨어 설치 매뉴얼 - 페이지 18

{카테고리_이름} Cisco IR530에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco IR530 28 페이지. Wpan gateway and wpan range extender

IR510 WPAN Gateway and IR530 WPAN Range Extender Hardware Installation Guide

IR530 Series Resilient Mesh Range Extender Installation

Table 9

IR530 Product IDs

Product ID

IR530-OFDM-FCC/K9

IR530-OFDM-BRZ/K9

IR530-OFDM-ANZ/K9

IR530 Range Extender Cautions and Warnings

CAUTION : Do not place anything on top of the router that weighs more than 10 pounds (4.5 kilograms), and do not stack routers on a

desktop. Excessive weight on top of the router could damage the chassis.

CAUTION : Do not install the router or power supplies next to a heat source of any kind, including heating vents.

WARNING : Read the installation instructions before connecting the system to the power source. Statement 1004

WARNING : This product relies on the building's installation for short-circuit (over current) protection. Ensure that the protective device is

rated not greater than: 5 Amps. Statement 1005

WARNING :This unit is intended for installation in restricted access areas. A restricted access area can be accessed only through the use of

a special tool, lock and key, or other means of security. Statement 1017

WARNING :This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably

installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable

grounding is available. Statement 1024

WARNING : Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030

WARNING : Ultimate disposal of this product should be handled according to all national laws and regulations.

Statement 1040

WARNING :To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended ambient

temperature of: 60C Statement 1047

WARNING : Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can come into contact

with such circuits. When installing the antenna, take extreme care not to come into contact with such circuits, because they may cause

serious injury or death. For proper installation and grounding of the antenna, please refer to national and local codes (for example,

U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical Code, Section 54). Statement 1052

WARNING : No user-serviceable parts inside. Do not open. Statement 1073

WARNING : This product is not intended to be directly connected to the Cable Distribution System. Additional regulatory compliance and

legal requirements may apply for direct connection to the Cable Distribution System. This product may connect to the Cable Distribution

System ONLY through a device that is approved for direct connection. Statement 1078

IR530 Range Extender Hardware Specifications

Table 10 on page 19

provides a highlight of the hardware specifications. For more details on product offerings such as antennas, cables, and

RF accessories as well as software specifications, compliance, immunity, emissions, safety and ingress protections (dust and water), please

refer to the

Cisco IR530 Series Resilient Mesh Range Extenders Data

Description

IR530 with 915MHz-WPAN, utility-grade DC power. For all

North and South America except Brazil.

IR530 with 915MHz-WPAN, utility-grade DC power. For Brazil.

IR530 with 915MHz-WPAN, utility-grade DC power. For

Australia and New Zealand.

Sheet.