Cisco Linksys WAG54G2 사용자 설명서 - 페이지 18
{카테고리_이름} Cisco Linksys WAG54G2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Linksys WAG54G2 33 페이지. Wireless adsl2+ gateway
페이지 인쇄Appendix D
you remove the equipment from the network until the
problem is resolved. This equipment cannot be used on
telephone company provided coin service. Connection to
Party Line Service is subject to state tariffs.
Safety Notices
Caution: To reduce the risk of fire, use only No.26 AWG
•
or larger telecommunication line cord.
Do not use this product near water, for example, in a
•
wet basement or near a swimming pool.
Avoid using this product during an electrical storm.
•
There may be a remote risk of electric shock from
lightning.
WARNING:
This equipment will be inoperable
when main power fails.
WARNING:
To
explosure limits to radiofrequency fields, the
antenna of the device should be no closer than
20 cm from the body during use.
Canada
The following information applies if you use the product
within Canada.
Industry Canada Statement
This device complies with Industry Canada ICES-003 and
RSS210 rules.
Wireless ADSL2+ Gateway
ensure
compliance
with
Regulatory Information
Operation is subject to the following two conditions:
1.
This device may not cause interference and
2.
This device must accept any interference, including
interference that may cause undesired operation of the
device. This device has been designed to operate with
an antenna having a maximum gain of 2dBi. Antenna
having a higher gain is strictly prohibited per regulations
of Industry Canada. The required antenna impedance
is 50 ohms.
To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen
that the EIRP is not more than required for successful
communication.
Industry Canada Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance
20cm between the radiator & your body.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Avis d'Industrie Canada
Cet appareil est conforme aux normes NMB003 et RSS210
d'Industrie Canada.
L'utilisation de ce dispositif est autorisée seulement aux
conditions suivantes :
1.
il ne doit pas produire de brouillage et
2.
il doit accepter tout brouillage radioélectrique reçu,
même si ce brouillage est susceptible de compromettre
le fonctionnement du dispositif. Le dispositif a été
conçu pour fonctionner avec une antenne ayant un gain
maximum de 2 dBi. Les règlements d'Industrie Canada
interdisent strictement l'utilisation d'antennes dont le
gain est supérieur à cette limite. L'impédance requise
de l'antenne est de 50 ohms.
Afin de réduire le risque d'interférence aux autres
utilisateurs, le type d'antenne et son gain doivent
être choisis de façon à ce que la puissance isotrope
rayonnée équivalente (p.i.r.e.) ne soit pas supérieure
au niveau requis pour obtenir une communication
satisfaisante.
Avis d'Industrie Canada concernant l'exposition aux radio-
fréquences :
Ce matériel est conforme aux limites établies par IC
en matière d'exposition aux radiofréquences dans un
environnement non contrôlé. Ce matériel doit être installé
et utilisé à une distance d'au moins 20 cm entre l'antenne
et le corps de l'utilisateur.
15