Cisco Physical Access CIAC-GW-K9 빠른 시작 매뉴얼 - 페이지 13
{카테고리_이름} Cisco Physical Access CIAC-GW-K9에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Physical Access CIAC-GW-K9 17 페이지. Physical access gateway
Cisco Physical Access CIAC-GW-K9에 대해서도 마찬가지입니다: 설치 및 구성 (26 페이지)
페이지 인쇄
6
Cisco Physical Access Input Module
What's In the Box
Each Cisco Input Module includes the following:
• 20 resistors (1K) for supervised input interfaces
• 2 mounting brackets, with 4 screws for each bracket
• Regulatory compliance and safety information
• Quick Start Guide
• Connector plugs:
Type
Quantity
3 Pin
1
2 Pin
13
Input Module and Port Descriptions
The Cisco Input Module includes 10 ports for connecting additional input devices, as shown in Figure 6.
Figure 6
Cisco Input Module Ports and Connectors
6
5
4
The following items are shown in Figure 6:
Type
Power
1
2
CAN interface
CAN terminator
3
Description
Two-pin connector for Voltage In (VIN) and Ground (GND) to connect a 12 to 24 VDC
external power source.
A 3-wire CAN interface used to connect the module to the CAN bus.
The CAN terminator switch should be set to ON for the last device in a CAN wiring bus.
This switch should be set to OFF for all other devices in the CAN bus.
1
2
3
13