Cisco Physical Access CIAC-GW-K9 설치 및 구성 - 페이지 15
{카테고리_이름} Cisco Physical Access CIAC-GW-K9에 대한 설치 및 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Physical Access CIAC-GW-K9 26 페이지. Physical access gateway
Cisco Physical Access CIAC-GW-K9에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (17 페이지)
페이지 인쇄
Chapter 2
Installing and Configuring the Cisco Physical Access Gateway
Configuring and Managing the Gateway Using a Direct
Connection
To enable the Gateway communication with the Cisco PAM appliance, connect a PC to the ETH1 port
and use a web browser to enter basic network settings, as described in this section. You can also use the
web administration tool to perform basic administration and monitoring tasks, such as upgrading the
module firmware or displaying the module serial number.
This section includes the following information:
•
•
•
•
•
•
You can also use the Cisco PAM desktop software to enter network settings and upgrade firmware
Tip
images. See the
page
Understanding Network Time Protocol (NTP) Settings
Cisco Systems strongly recommends using a network time protocol (NTP) server to synchronize the date
and time clock on each Gateway module, and on the Cisco PAM appliance. This ensures that events and
messages between the server and the Gateway modules are in sync. If the time and date are not
synchronized, inconsistent system behavior can occur.
We strongly recommend using the same NTP server setting for the Cisco PAM appliance, and for all
Gateway modules.
•
•
OL-32499-01
Understanding Network Time Protocol (NTP) Settings
Connecting a PC to the Gateway
Entering the Gateway Network Settings
Changing the User Password
Upgrading the Gateway Firmware Using a Direct Connection
Displaying Serial Numbers and Other Information
"Configuring the Gateway Using the Cisco Physical Access Manager" section on
2-24.
Gateways can receive the NTP server setting from a DHCP server, or by using the Cisco PAM
desktop software.
To enter the Gateway DHCP settings, see the
–
on page
2-17.
If DHCP is used to define the Gateway NTP server, any NTP settings defined using the
–
Cisco PAM desktop software will not apply (the DHCP configuration takes precedence).
To enter the NTP setting for a single Gateway using Cisco PAM desktop software, choose
–
Hardware from the Doors menu, right-click a Gateway module, and choose Set Gateway
Address.
Beginning with Cisco PAM Release 1.3.0, you can also change the NTP server setting for
–
multiple Gateways (Right-click the Access GW Driver and choose the Set NTP Server
command). See the
Cisco Physical Access Manager User Guide
To enter the NTP setting on the Cisco PAM server, use the Cisco PAM web administration tool. See
the
Cisco Physical Access Manager User Guide
Configuring and Managing the Gateway Using a Direct Connection
"Entering the Gateway Network Settings" section
for instructions.
for instructions.
Cisco Physical Access Gateway User Guide
2-15