Cisco Physical Access CIAC-GW-K9 설치 및 구성 - 페이지 18
{카테고리_이름} Cisco Physical Access CIAC-GW-K9에 대한 설치 및 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Physical Access CIAC-GW-K9 26 페이지. Physical access gateway
Cisco Physical Access CIAC-GW-K9에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (17 페이지)
페이지 인쇄
Configuring and Managing the Gateway Using a Direct Connection
Figure 2-13
(Optional) Enter the DNS Server address if names (not IP addresses) are used for the CPAM address.
Step 2
Step 3
Enter the Cisco PAM Configuration:
a.
Enter the Cisco PAM IP Address (IP address or name) to enable Gateway communication with the
appliance.
b.
Enter the Port number for the Cisco PAM appliance. The port number must be greater than 1024 and
less 65535. The default is 8020.
Tip
Enable SSL: The secure socket layer (SSL) is enabled for secure communication between the
c.
Gateway and Cisco PAM appliance by default. If necessary SSL can be disabled by unchecking the
Enable SSL check box.
Note
Click Save to save the settings. Wait until the Gateway resets and the web browser displays the screen
Step 4
Network Settings Applied. Or click:
–
–
Cisco Physical Access Gateway User Guide
2-18
Network Settings for the Cisco Physical Access Gateway
DHCP can also be configured to supply the Gateway with the IP address of the Cisco PAM
appliance by configuring option 150 in the DHCP response. The Cisco PAM appliance TCP port
number can be provided by DHCP option 151 of the DHCP response.
SSL is enabled by default on all Gateways and Cisco PAM appliances. If SSL is disabled for a
Gateway but enabled for Cisco PAM, the Gateway will not be able to connect to the appliance.
If the SSL settings are changed, reset all Gateways and the Cisco PAM appliance. We
recommend enabling SSL to ensure secure communications.
Reset Application: The Reset Application restarts the Gateway to clear any software issues.
The Gateway reconnects with the server (CPAM) after reset.
Reboot: The Reboot command reloads the device firmware and all
configuration/settings(re-initialized). This does not impact stored data. Again the Gateway
reconnects with the server after reload.
Chapter 2
Installing and Configuring the Cisco Physical Access Gateway
OL-32499-01