Cisco S195 하드웨어 설치 매뉴얼 - 페이지 43

{카테고리_이름} Cisco S195에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco S195 50 페이지. Web security appliance
Cisco S195에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (18 페이지), 매뉴얼 (24 페이지)

페이지 인쇄

Maintenance and Upgrades

Reset the Chassis Remotely

If the chassis requires a hard reset, you can reboot the chassis remotely using a third-party IPMI tool.

Before you begin

• You must enable RPC in advance. See

• Only the following IPMI commands are supported. Refer to your IPMI tool documentation on how to

• Set up a utility that can manage devices using IPMI version 2.0.

Step 1

Use IPMI to issue a supported power-cycling command to the IP address assign to the RPC port.

Note

The RPC port must be configured with the required credentials. See

information.

For example, issue the following command from a UNIX computer with IPMI support:

ipmitool -I lan -H ip-address -U remoteresetuser -P password chassis power reset

Step 2

Wait at least 11 minutes for the chassis to reboot.

Install/Uninstall the Locking Faceplate

The locking faceplate (Cisco part number 74-115098-01 for a 1 RU chassis and Cisco part number 74-115099-01

for a 2 RU chassis) ships with the key you need to lock the faceplate to the front panel of the chassis. The

locking faceplate clicks in between the two side handles on the front panel.

Step 1

Insert the right side of the locking faceplate by aligning the two plastic tabs with the two cutouts on the right side handle

on the front of the chassis.

use them.

status, on, off, cycle, reset, diag, soft

Cisco Web Security Appliance S195, S395, S695, and S695F Hardware Installation Guide

Enable RPC, on page 38

for the procedure.

Enable RPC, on page 38

Reset the Chassis Remotely

for more