Cisco S395 하드웨어 설치 매뉴얼 - 페이지 41

{카테고리_이름} Cisco S395에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco S395 50 페이지. Web security appliance
Cisco S395에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (18 페이지), 매뉴얼 (24 페이지)

페이지 인쇄

Maintenance and Upgrades

•

Power Button Shut Down

The chassis runs in two modes:

• Main power mode—Power is supplied to all components and all operating systems can run.

• Standby power mode—Power is supplied only to the service processor and certain components. You can

Caution

After you shut down the chassis to standby power, electric current is still present in the chassis. To completely

remove power as directed in some maintenance procedures, you must disconnect all power cords from all

power supplies in the chassis.

You can shut down the chassis using the front panel Power button or software management.

Step 1

Check the Power LED:

• Amber—The chassis is already in standby mode and you can safely remove power.

• Green—The chassis is in main power mode and you must shut it down before you can safely remove power.

Step 2

Perform a graceful shutdown or a hard shutdown:

Caution

To avoid data loss or damage to your operating system, perform a graceful shutdown of the operating system.

• Graceful shutdown—Press and release the Power button. The operating system performs a graceful shutdown and

the chassis goes into standby mode. The power LED is amber.

Power Button Shut Down, on page 37

Enable RPC, on page 38

Reset the Chassis Remotely, on page 39

Install/Uninstall the Locking Faceplate, on page 39

Remove and Replace a Drive, on page 40

Remove and Replace a Power Supply, on page 43

safely remove power cords from the chassis in this mode.

Cisco Web Security Appliance S195, S395, S695, and S695F Hardware Installation Guide

C H A P T E R