Cisco S695 시작하기 매뉴얼 - 페이지 9

{카테고리_이름} Cisco S695에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco S695 18 페이지. Web security appliance
Cisco S695에 대해서도 마찬가지입니다: 매뉴얼 (24 페이지), 하드웨어 설치 매뉴얼 (50 페이지)

페이지 인쇄

If you turn the power off before the initialization is complete, the appliance will not reach an operational

Caution

state and must be returned to Cisco.

If turned on quickly after connecting power to the appliance, the appliance powers up, the fans spin and

Note

the LEDs turn on. Within 30-60 seconds, the fans stop and all LEDs turn off. The appliance powers on

31 seconds later. This behavior is by design to allow the system firmware and controller to synchronize.

See the

Step 6

Cisco S395 Appliance

Plug one end of each straight power cable into the redundant power supplies on the back panel of the

Step 1

appliance.

Plug the other end into an electrical outlet.

Step 2

Plug the Ethernet cables into the appropriate ports on the back panel of the appliance.

Step 3

•

Connect your laptop to the Management port using the Ethernet cable included in the system box. The

Step 4

S-Series appliance uses the M1 Management port only.

AsyncOS for Cisco Web Security Appliances User Guide

The proxy ports are labeled P1 and P2.

P1 only enabled: When only P1 is enabled, connect it to the network for both incoming and

–

outgoing traffic.

P1 and P2 enabled: When both P1 and P2 are enabled, you must connect P1 to the internal

–

network and P2 to the internet.

The traffic monitor ports are labeled T1 and T2.

Simplex tap: Ports T1 and T2; one cable for all packets destined for the internet (T1) and one

–

cable for all packets coming from the internet (T2).

Duplex tap: Port T1; one cable for all incoming and outgoing traffic.

–

Cisco Web Security Appliance S195, S395, S695, and S695F Getting Started Guide

Connect to the Appliance

for further configuration.