Cisco S695 하드웨어 설치 매뉴얼 - 페이지 42

{카테고리_이름} Cisco S695에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco S695 50 페이지. Web security appliance
Cisco S695에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (18 페이지), 매뉴얼 (24 페이지)

페이지 인쇄

Enable RPC

• Emergency shutdown—Press and hold the Power button for four seconds to force the main power off and immediately

enter standby mode.

Step 3

If a maintenance procedure instructs you to completely remove power from the chassis, disconnect all power cords from

the power supplies.

Enable RPC

You must enable and configure RPC before you can remotely reset chassis power.

Before you begin

• Cable the RPC port directly to a secure network.

• Open necessary ports through the firewall to make sure the chassis is accessible remotely.

• RPC requires a unique IPv4 address for the RPC port. You must use the following procedure to configure

• To cycle chassis power you must have a third-party tool that supports the Intelligent Platform Management

Step 1

Use SSH or the serial console port to access the CLI.

Step 2

Step 3

Enter the following commands:

remotepower

setup

Step 4

Follow the prompts to specify the following:

• The dedicated IP address for the RPC port, netmask, and gateway.

• The username and password required to execute the power-cycle command.

These credentials are independent of other credentials used to access your appliance. Store this information for

administrators who may need to set up RPC in the future.

Step 5

Enter commit to save your changes.

Step 6

Test your configuration to verify that you can remotely manage chassis power.

What to do next

Reset the Chassis Remotely, on page 39

Cisco Web Security Appliance S195, S395, S695, and S695F Hardware Installation Guide

the RPC port. You cannot configure it using the ipconfig command.

Interface (IPMI) version 2.0.

Maintenance and Upgrades