Cisco SM-X-24FXS/4FXO 하드웨어 설치 매뉴얼 - 페이지 28

{카테고리_이름} Cisco SM-X-24FXS/4FXO에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SM-X-24FXS/4FXO 40 페이지. Voice gateway

Power-On Procedure

• Power cable is connected

• Interface cables are connected

SUMMARY STEPS

1. Power on your terminal or PC, and configure it for 9600 bps, 8 data bits, 1 stop bit, and no parity.

2. Move the Cisco VG400 Voice Gateway power switch to the ON position.

3. Enter no to proceed with manual configuration using the CLI:

4. Press Return to terminate autoinstall and continue with manual configuration.

5. Press Return to bring up the Router> prompt:

6. Enter privileged EXEC mode:

7. Continue with the

DETAILED STEPS

Step 1

Power on your terminal or PC, and configure it for 9600 bps, 8 data bits, 1 stop bit, and no parity.

Step 2

Move the Cisco VG400 Voice Gateway power switch to the ON position.

The green LED next to the auxiliary port comes on and the fan starts to operate. If this does not happen, see the

Troubleshooting, on page 29

The following message is displayed at the end of the boot-up messages:

Example:

--- System Configuration Dialog ---

Would you like to enter the initial configuration dialog? [yes/no]:

Step 3

Enter no to proceed with manual configuration using the CLI:

Example:

Would you like to enter the initial configuration dialog? [yes/no]: no

Would you like to terminate autoinstall? [yes]

Step 4

Press Return to terminate autoinstall and continue with manual configuration.

Several messages are displayed, ending with a line similar to the following:

Example:

...

Compiled <date

> <time

> by <person

Step 5

Press Return to bring up the Router> prompt:

Example:

...

Cisco VG400 Voice Gateway Hardware Installation Guide

Troubleshooting, on page 29

section.

Installing the Cisco VG400 Voice Gateway

section.