Cisco T3 설치 매뉴얼 - 페이지 4

{카테고리_이름} Cisco T3에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco T3 9 페이지. Network modules
Cisco T3에 대해서도 마찬가지입니다: 연결 매뉴얼 (4 페이지)

Router# show busyout slot-number

Step 4 You may use the clear port command to immediately disable active calls on the universal

port card. Use the show controller command to show the universal port card associated with the

T1 or E1 DFC.

Router# show controller t1/e1 slot-number/control-number timeslot timeslot-

number

Router# clear port slot-number/port number

Note The clear port command only applies to the universal port DFC.

Step 5 Verify that the OIR/MAINT LED is off; this indicates that the DFC is offline and ready

to be removed.

Note The OK/MAINT LED is green before you enter the busyout command. After you enter the

busyout command, the LED changes to yellow. The LED turns off after all calls are

disconnected and resources are taken out of service, indicating that busyout is complete.

Step 6 Attach an ESD-preventive wrist strap.

Warning Do not work on the system or connect or disconnect cables during periods of lightning

activity. To see translations of the warnings that appear in this publication, refer to the

Regulatory Compliance and Safety Information document that accompanied this device.

Step 7 Disconnect all interface cables from the DFC and secure them out of the way.