Cisco VG204XM 빠른 시작 매뉴얼 - 페이지 10

{카테고리_이름} Cisco VG204XM에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco VG204XM 19 페이지. Voice gateways
Cisco VG204XM에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (48 페이지)

페이지 인쇄

Do not place anything that weighs more than 5 pounds (2.25 kg) on top of the chassis. Do not stack chassis on a

Caution

desktop. Excessive distributed weight of more than 5 pounds or a pound point load of 5 pounds on top can damage

the chassis.

After you install the chassis, connect it to a reliable earth ground. For the chassis ground connection procedures, see the

"Grounding the Chassis" section on page

Mounting the Chassis onto a Wall

You can mount the voice gateway chassis onto a wall or other vertical surface by using the molded mounting brackets on the

bottom of the chassis and two number-six, 3/4-inch (M3.5 x 20 mm) screws. You must provide the screws.

mounting-screw slots on the chassis.

Caution

If you are mounting the chassis onto drywall, use two hollow-wall anchors (1/8 inch with 5/16-inch drill bit, or M3

with 8-mm drill bit) to secure the screws. If the screws are not properly anchored, the strain of the network cable

connections could pull the chassis from the wall.

Figure 6

Mounting-Screw Slots for Wall-Mounting the Cisco VG202, Cisco VG202XM, Cisco VG204, or Cisco VG204XM Voice

Gateway Chassis

Rubber feet

Before You Begin

Ensure that you meet the following conditions when you mount the chassis onto a wall:

• The LEDs on the front panel face upward and are easily visible, because you will use the LEDs as status and problem

indicators.

• The back panel faces downward, to reduce strain on the cable connections.

• The power supply rests on a horizontal surface such as the floor or a table. If the power supply is not supported, it can place

strain on the power supply cable and cause it to disconnect from the connector on the back panel of the chassis.

12.

Mounting-screw slots

Figure 6

shows the