Cisco VG224 - Analog Phone Gateway 빠른 시작 매뉴얼 - 페이지 6
{카테고리_이름} Cisco VG224 - Analog Phone Gateway에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco VG224 - Analog Phone Gateway 21 페이지. Inserting gateways
Cisco VG224 - Analog Phone Gateway에 대해서도 마찬가지입니다: 매뉴얼 (10 페이지)
페이지 인쇄
safety warnings that accompanied this device.
Note: SAVE THESE INSTRUCTIONS
Note: This documentation is to be used in conjunction with the specific product installation guide that shipped
with the product. Statement 1071
Warning
Only trained and qualified personnel should be allowed to install or replace this equipment. Statement 1030
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be accessed only
through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement 1040
Warning
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260. Incorrectly
connecting this equipment to a general-purpose outlet could be hazardous. The telecommunications lines must be
disconnected 1) before unplugging the main power connector or 2) while the housing is open, or both. Statement
1043
Warning
Blank faceplates and cover panels serve three important functions: they prevent exposure to hazardous voltages
and currents inside the chassis; they contain electromagnetic interference (EMI) that might disrupt other
equipment; and they direct the flow of cooling air through the chassis. Do not operate the system unless all cards,
faceplates, front covers, and rear covers are in place. Statement 1029
Chassis Installation Options
You can set the chassis on a desktop, install it in a rack, or mount it on a wall.
Before proceeding, consider the location of the equipment with respect to a good ground. See the "Grounding the
Tip
Chassis" section on page 10.
See the following instructions:
• Using Quick Installation Brackets, page 7
• Using the Correct Bracket Screws, page 6
• Rack-Mounting the Chassis, page 7
• Wall-Mounting the Chassis, page 8
• Grounding the Chassis, page 10
Caution
Use only the mounting hardware supplied with this product.
Using the Correct Bracket Screws
Two sets of bracket attachment screws are provided, in separate packages. Take care to use each screw type, and washers as
needed, in the appropriate locations. Table 1 summarizes the bracket attachment screw types.
6