Epson Stylus CX7450 빠른 매뉴얼 - 페이지 37

{카테고리_이름} Epson Stylus CX7450에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Stylus CX7450 48 페이지. Epson scan icm updater v1.20 (psb.2008.07.001)
Epson Stylus CX7450에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지), 사용자 설명서 (12 페이지), 업데이트 (1 페이지)

페이지 인쇄

■

If paper is jammed, follow these steps:

1. Gently pull out jammed paper from the output tray or sheet feeder.

2. If paper is stuck inside, turn off the CX7400 Series.

3. Open the scanner, remove the jammed paper and torn pieces, close the

scanner, and turn the CX7400 Series back on.

Print Quality Problems

If you have any problems with the copy or print quality, try these solutions:

■

Make sure the document is placed flat against the document table glass and

the CX7400 Series is not tilted or placed on an uneven surface.

■

Load the paper printable side up (usually the whiter, brighter, or glossy side).

■

Make sure your paper isn't damp or curled.

■

Use a support sheet with special paper or load your paper one sheet at a time.

Remove sheets from the output tray so not too many collect at a time.

■

Make sure the type of paper you loaded matches the paper size and paper type

settings in your printer software (see page 23).

■

For the best print quality, use Epson special paper (see page 6) and genuine

Epson ink cartridges (see page 28).

■

If you notice light or dark bands across your printouts or they are too faint,

you may need to clean the print head (see page 27). This unclogs the nozzles

so they can deliver ink properly. Run a nozzle check as described on page 26

to see if the print head needs cleaning.

■

Clean the print head as described on page 27.

■

If you notice jagged vertical lines, you may need to align the print head. See

your User's Guide for instructions.

■

The ink cartridges may be low on ink. Check your cartridge status (see

page 28) and replace cartridges, if necessary (see page 29).

■

If a dotted line appears in the image, clean the document table glass with a

soft, dry, lint-free cloth (paper towels are not recommended), or use a small

amount of glass cleaner on a soft cloth, if necessary. Do not spray glass cleaner

directly on the glass.

Problems and Solutions