Epson Stylus Photo RX600 여기에서 시작하기 매뉴얼 - 페이지 8

{카테고리_이름} Epson Stylus Photo RX600에 대한 여기에서 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Stylus Photo RX600 10 페이지. Product support bulletin(s)
Epson Stylus Photo RX600에 대해서도 마찬가지입니다: 팁 (2 페이지), 제품 정보 시트 (4 페이지), 제품 정보 (19 페이지), 브로셔 (2 페이지), 설정 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (28 페이지), 사용자 설명서 (12 페이지), 업데이트 (1 페이지), 제품 지원 게시판 (6 페이지), 제품 지원 게시판 (1 페이지), 사양 (2 페이지), 복사 및 인쇄 방법 (20 페이지), 사용 설명서 (4 페이지)

페이지 인쇄

Selecting the RX600 in Mac OS X

Open the OS X Applications folder, then open the Utilities folder and

start Print Center or the Printer Setup Utility.

Note: If you see a screen asking if you'd like to add a printer, click Add.

On the Printer List screen, click the Add button.

On the next screen, select EPSON

USB from the pull-down menu.

Click Stylus Photo RX600.

Note: If the RX600 doesn't

appear, make sure it is turned

on and securely connected to

your Macintosh.

Open the Page Setup menu at the

bottom of the screen and select All.

Click the Add button. The Printer List

now includes two entries for your printer.

Close Print Center or the Printer

Setup Utility.

If you print or scan with Mac OS 9 applications, restart your Macintosh

in OS 9 and repeat all the steps under "Macintosh" to install the

necessary software for them. Then remove the CD-ROM.

Selecting the RX600 in Mac OS 9

Open the Chooser from the Apple menu.

Select the SP RX600 Series icon, then

click your USB port icon and turn on

background printing.

Close the Chooser.

Now you're ready to copy, scan, and print! See "Any Questions?" to the right

to find out how.

Any Problems?

If the red

error light is on, check for messages on the RX600 LCD screen.

They give you guidance for solving problems.

If your problem is listed below, try the suggestions here. For more solutions,

see your User's Guide.

A New Hardware Wizard

screen appears on your

computer.

You see an error message

when printing or

scanning.

The RX600 doesn't work.

Click Cancel and follow the steps in section 8.

Disconnect the RX600 cable before installing

software.

Make sure your RX600 is connected to your

computer, plugged into a power source, and

turned on.

Try turning the RX600 off and then back on to

clear the error.

Unlock the scanner by sliding the transportation

lock. See section 2.

Unlock the printer by removing and storing the

orange plastic print head lock. See section 4.

Make sure all the ink cartridges are pushed down

all the way. See section 6.

Try connecting the USB cable to a different USB

port on your computer. See section 8.

Turn the RX600 off and then on again.

If it still doesn't work, try reinstalling your

software. See section 8.