Epson TWAIN v 1.0 제품 지원 게시판 - 페이지 17

{카테고리_이름} Epson TWAIN v 1.0에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson TWAIN v 1.0 19 페이지. Epson es-1200c: support bulletin

EPL-7000 cont.

[S] WARMING UP

The printer is warming up.

Note:

If any of the following messages appear, turn the printer off for at least five

seconds, then turn it back on. If the same message is displayed, repair is

required.

SCAN MOTOR ERROR

HSYNC ERROR

HEATER LAMP ERROR

MAIN MOTOR ERROR

FAN MOTOR ERROR

ES300C Display Codes

E-C

Command error. An unidentified command or parameter was detected.

E-l Interface error

a. Incorrect communication parameter received.

b. Broken connector or wire.

c. Host failed to respond within 30 seconds.

d. Host is not accepting data. (DSR= Low)

E-F Fatal error

a. A lamp is broken.

b. Power is applied before the transportation screws were removed.

c. System failure

GQ-3500 Display Codes

Cover Open error

Engine driver CPU error.

Option tray CPU error.

Option tray motor error.

PSB No: P-0077

Page: 9 of 11