DIGIWAY PTY P550 사용 설명서 - 페이지 9

{카테고리_이름} DIGIWAY PTY P550에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIGIWAY PTY P550 12 페이지. Sliding gate motor
DIGIWAY PTY P550에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지)

페이지 인쇄

8. Manual release

P550 and P750 have different manual release mechanisms please read the

instructions carefully.

8.1 P550 manual release

A: What to do during a power failure:

The gate can be manually pushed open and close if there is no power. To do this, you need to release

the release bolt.

(1) Switch off the power switch at the mains supply.

(2) Open the front flap and insert the spanner (provided) into the hole. The spanner should fit onto

the bolt nicely.

(3) Rotate the spanner anti-clockwise several times (6-8 turns) until light resistance is felt. Do

not force.

(4) The gate can now be manually opened and closed.

B: What to do if power is reconnected:

At this stage, the gate should be able to be pushed open and close manually (using hands). If not, read

and carry out instructions in 'What to do during a power failure' first, before carrying out these

instructions.

(1) Make sure the switch at the power point is still switched OFF.

(2) Open the front flap and insert the spanner (provided) into the hole. The spanner should fit onto

the bolt nicely.

(3) Rotate the spanner clockwise until light resistance is felt. Do not force.

(4) (a) Manually push or pull the gate until a clicking noise is heard or if it cannot be pushed any

further.

(b) If no click is heard AND the gate is still able to be pushed fully open, turn the spanner

clockwise a little more (half a turn – Do not use force) and try this step 4(a) again.

(5) If needed, rotate the spanner clockwise again until finger-tightness is felt. Do not force.

(6) Turn on the power at the power point. , the gate should start to close if no signal input on PEB

(safety) and OPN (open) inputs. When gate hit on receiving post, the controller will recall the

all the settings and ready to operate.

DIGIWAY PTY LTD

MANUAL RELEASE