DigiWeight DWP-102E 사용자 설명서 - 페이지 9

{카테고리_이름} DigiWeight DWP-102E에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DigiWeight DWP-102E 10 페이지. Floor / pallet scale

SLP 5: The indicator will enter sleep mode if it is idle for 5 minutes.

SLP 10: The indicator will enter sleep mode if it is idle for 10 minutes.

Press [FUN] to select and [TARE] to move to the next parameter.

4.3 "F3 KEY" FUNCTION SWITCH

Press [FUN] to enter function select. Press [TARE] key to switch among:

Key1: Counting, Gross/Net Weight Display

Key2: Accumulation & Print

Key3: Weight Holding

Key4: Pre-tare Function

Key5: Animal Weighing

4.4 "F4 CHK" CHECKING WEIGHING SETTING

Options: BEEP 1/2/3

4.5 "F5 BRT" BRIGHTNESS

Press [FUN] to change LED brightness. Press [TARE] to switch from 1-8. 8 is the most bright and

most power-consuming.

4.6 "F6 INP" INTERNAL COUNT DISPLAY

Press [FUN] to display the scale internal count.

4.7 "F7 CAL" CALIBRATION

Press [FUN] to enter calibration.

PN: Password. Press [TARE] to change the first digit to be 0, then press [ZERO] to move to the next

digit...in this way enter the password 0000. Then press [FUN] to enter the calibration.

"P1 SP": Set AD converting speed. Options: 1/2/3/4/5. 1 is the fastest and 5 is the slowest

"P2 AUT": Set Power-on Zero Range. Options: 0/2/5/10/20/50/100% of the capacity

"P3 RAN": Set Manual Zero Range. Options: 2/4/10/20/50/100% of the capacity

"P4 AZ": Set Auto Zero Range. Options: 0.25d/0.5d/1d/2d/4d/Off d=division

"P5 DEC": Set the decimal points. Options: 0/0.0/0.00/0.000/0.0000

"P6 CAP": Set Full Capacity.

"P7 INC": Set Division Increment. Options: 1/2/5/10/20/50

"P8 CAL": Calibration. We recommend complete the set up before calibration. So we skip the details

of calibration here and we will show to how to calibrate in Chapter 5. For now press [TARE] to go to

the next parameter.

"P9 INT": Factory Setting. Please do not set this parameter if you are not sure to do so.

"P10 RS": Communication Mode. This is for RS232 output setting. Press [FUN] to set up baud rate:

1200/2400/4800/9600/19200 Press [FUN] to confirm and go to print mode selection:

PRT: Used for serial printer

AUT: Used for transmission after each load

COT: Used for continuous transmission to PC or remote display

Floor / Pallet Scale

- 8 -