Epson C094001 - FX 870 B/W Dot-matrix Printer 사양 - 페이지 9
{카테고리_이름} Epson C094001 - FX 870 B/W Dot-matrix Printer에 대한 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson C094001 - FX 870 B/W Dot-matrix Printer 12 페이지. Hi-capacity cut-sheet feeder
Epson C094001 - FX 870 B/W Dot-matrix Printer에 대해서도 마찬가지입니다: 조립 설명서 (8 페이지)
![Epson C094001 - FX 870 B/W Dot-matrix Printer 사양](/uploads/products/server2/598754/598754.png)
Changing Group 3 default settings
Group 3 default settings differ from 1 and 2. You determine
the setting by the number of beeps you hear instead of
checking the panel lights. Also, the printer does not print a
list of Group 3 default settings. To change Group 3 default
settings follow the steps below.
PAUSE
2. Hold down the
and
FONT, PAUSE,
3.
Press the
change the current setting. The printer beeps once or twice
to indicate your setting.
Button
PAUSE
Draft print speed
PAPER FEED
FONT
Auto carriage return
For example if you press the
becomes invalid and the printer beeps once.
Note:
entering this mode, the printer beeps five times and
the settings unchanged.
Once you change a feature's
without j?rst exiting and reentering Group 3 default-setting
After you make your changes, wait until the
on. This shows that the printer has automatically
comes
exited the setting mode and you can begin printing.
Character Fonts
Your printer has two draft fonts (normal and high-speed) and
two Near Letter Quality (NLQ) fonts (Epson Roman and
Epson !%ns Serif). You can select these through application
software and the control panel.
Use the default-setting mode (explained earlier) to choose
between normal and high-speed draft.
From the control panel you can select normal or condensed
versions of all the fonts. Condensed characters are 60 percent
as wide as normal characters.
FONT
button and the
select the font you want. Each time you press the
button, the selection changes and the
lights come on, go off, of7bli$ to indicate the current
selection (I On
9-Pin Printers
PAPER FEED
buttons while you
PAPER FEED
button if you want to
or
High
Valid
PAUSE
button, the input buffer
you cannot change it again
setting,
READY
FONT
CONDENSED
and
lights to
FONT
FONT
CONDENSED
and
Note: The settings you selectfrom the control panel remain in
because some application programs control character fonts
and because program commands often override panel
settings, use your application program's print options instead
of the control panel to select character fonts if possible.
Once
Here are sample characters for each font.
Twice
Normal Draft
Once
Normal Draft condensed
Epson Roman
light
Epson San Serif
Epson San Serif condensed
10/13/92
FX-870/1170
FX-870/1170-9