Acuity Brands Lighting AAWB 매뉴얼 - 페이지 10

{카테고리_이름} Acuity Brands Lighting AAWB에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acuity Brands Lighting AAWB 18 페이지.

Installation Instructions

RSX LED

RSXF INTEGRAL SLIPFITTER (IS) INSTALLATION ON VERTICAL TENONS (+/- 5 °)

Note: Luminaire can be tilted up to 90 degrees (maximum) above horizontal.

Tools Required:

• 9/64" Allen Wrench

• 5/16" Allen Wrench

• 3/8" Allen Wrench

Maximum tenon/pole diameter: 2" schedule 40

pipe (2-3/8" OD)

NOTE: This luminaire is pre-wired with UL listed

supply wire leads. It is not necessary to access

fixture housing to install or wire the luminaire.

1. Remove the two (2) 8-32 splice access cover

fasteners from knuckle assembly, remove the

splice access cover, and pull supply wire leads

from knuckle cavity (See figures 13a and 13b)

2. Slip luminaire knuckle fitter over 2-3/8" Ø

pole tenon and evenly tighten the six (6) 3/8-16

UNC knuckle tenon set screws to 23-27 ft-lbs,

while maintaining the correct position of the

luminaire

3. Cut and splice the wires. Recommended cut

length is 6" for wires for ease of splicing and

securing in the knuckle

4. Make all wiring connections via the supplied

wire leads in accordance with NEC and local

codes.

5. Push all fixture and supply wires completely

within the knuckle cavity and replace the splice

access cover, gasket, and two (2) 8-32 splice ac-

cess cover fasteners.

Lithonia Lighting Outdoor

One Lithonia Way, Conyers, GA 30012

Phone: 800-279-8041 Fax: 770-918-1209

www.lithonia.com

Part Number: IM-459 Rev A

Revision Date: 8/29/19

Page #8