Epson DLQ-3500 빠른 매뉴얼 - 페이지 20

{카테고리_이름} Epson DLQ-3500에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson DLQ-3500 32 페이지. Epson serial impact dot matrix printers
Epson DLQ-3500에 대해서도 마찬가지입니다: 설정 매뉴얼 (31 페이지), 공지 사항 (1 페이지), 참조 매뉴얼 (34 페이지)

페이지 인쇄

Special Papers

Multipart forms

Your printer can print on both single-sheet

and continuous multipart forms. It can use

multipart forms with up to eight parts

including the original.

Caution:

Use only carbonless multipart forms.

Before printing, set the paper-thickness lever

to the appropriate position for your

multipart forms referring to the table in

"Paper-Thickness Settings."

You can load single-sheet multipart forms

from the paper guide, or with the optional

cut-sheet feeder or optional automatic sheet

alignment unit. For instructions, see "Single

Sheets with the Paper Guide," "Loading

paper to the cut-sheet feeder" or "Single

Sheets with the Automatic Sheet Alignment

Unit." You can load continuous multipart

forms in the same way as you load ordinary

continuous paper. For instructions, see

"Continuous Paper."

Caution:

❏ When printing on multipart forms,

make sure that your software settings

keep the printing entirely within the

printable area of the forms. Printing

on the edge of a multipart form can

damage the print head. For

information about the printable area,

see "Printable area" in the Reference

Guide.

❏ Single-sheet multipart forms that are

glued at the side of the form should be

loaded only from the paper guide, not

from the optional cut-sheet feeder.

EPSON DLQ-3500 Quick Guide

Overlapping multipart forms

Overlapping multipart forms are a type of

continuous paper with multipart forms. The

page length of the multipart forms is longer

than that of the backing continuous paper.

So when extended, one page's multipart

forms overlap the next page's multipart

forms as shown below. This overlapping

area is thicker than the printable area.

Follow these steps to load overlapping

multipart forms:

Caution:

Use overlapping multipart forms only

under normal operating conditions.

1. Make sure of the following:

❏ Your software settings keep the

printing entirely within the

printable area. See "Printable area"

in the Reference Guide for more

information.

❏ Tractor is selected as the paper

source on the control panel.

❏ The setting of the page length for

tractor in the default settings

matches the page length of the form

you use. See "Changing default

settings" for more information.

Special Papers (1/6)