Acuity Brands Lighting Lithonia Lighting LDN8 SWW 설치 지침 매뉴얼 - 페이지 3

{카테고리_이름} Acuity Brands Lighting Lithonia Lighting LDN8 SWW에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acuity Brands Lighting Lithonia Lighting LDN8 SWW 15 페이지.

페이지 인쇄

B) Important Safety Information - For Your Protection, Read Carefully

Warning: Risk of fire. For Non-IC rated luminaires, do not install insulation within 3 inches of fixture sides or wiring compartment, nor

above fixture in such a manner as to entrap heat.

Electric current can cause painful shock or serious injury unless handled properly. For your safety, always remember the following:

Turn off the supply power. Do not energize the luminaire until installation is complete.

•

Ground the luminaire to avoid potential electrical shocks.

•

Do not handle an energized luminaire or energize any luminaire with wet hands, when standing on a wet or damp surface, or

in water.

C) Lay-in Panel T-bar Ceiling Installation

8-3/4"

Hole

Cut ceiling opening slightly larger than the

outside diameter on the mounting frame.

8-3/4" diameter opening.

Position mounting frame through opening

in ceiling.

Cam

Assemble the channel bars to each side of the

mounting frame with the included hardware.

Leave the cams loose to adjust the position of

the frame in the ceiling.

Channel bar hooks

Hook channel bars over T-bar and secure

to T-bar by means of wire ties.

Lithonia Lighting

1400 Lester Road Conyers Georgia 30012

P 800 315 4935 F 770 860 3129

Technical Support P 800-705-7378

www.Lithonia.com

Adjust channel bars to the correct spacing

between T-bar. See Page 5 for procedure

for non-accessible ceiling installation.

Mounting Frame

1/8" Max

Ceiling Line

Adjust the mounting frame vertically to

align the bottom edge of the draw-down

to either flush or slightly above (1/8" max)

the ceiling line.

912-00206-001 Rev. A

Draw-down

Page 3