TomTom Navigator Navigator 3 빠른 시작 매뉴얼 - 페이지 25
{카테고리_이름} TomTom Navigator Navigator 3에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. TomTom Navigator Navigator 3 44 페이지. Wireless gps receiver
TomTom Navigator Navigator 3에 대해서도 마찬가지입니다: 사용자 설명서 (47 페이지), 사용자 설명서 (14 페이지), 사용자 설명서 (12 페이지)
페이지 인쇄Go to co-
ordinates...
Zoom font +/-
Avoid area
Clear avoid
(s)...
Legend...
How to view a planned route
When you have planned a route, TomTom Navigator provides a table with detailed instructions. You
can view this list by selecting the "Instructions" view from the pull-down view-switching menu (1) in
the top-left corner. You can also divide the screen between this list and the map by selecting "Split
View" in the view selector (4).
The "Instructions" view allows you to review a planned route and to plan ahead. Each individual
instruction provides additional information:
Tap on an instruction - in the "Instructions" view, this pops up full-screen details about the
instruction, including a small map; in the "Split View", tapping on an instruction highlights it,
and causes the cursor on the map to move to the location involved in the instruction.
Tap and hold an instruction - pops up an action list with similar options as when tapping and
holding a location on the map. At the very least, it allows you to show the specific location of
the instruction on the screen. From there (with another tap and hold) you can get access to all
other options.
3. The Favourites view
TomTom Navigator allows you to maintain a list of up to 20 "favourite" locations.
Favourite locations can be accessed very easily. For example, you can start navigating to a favourite
location with only a few taps of your finger.
Allows you to find a specific location by entering longitude and latitude.
Adjusts the size of the letters used to display names on the map.
Specifies a rectangular area on the map that needs to be avoided when
planning a route. TomTom Navigator will plan routes around such an
area (but not when for example your destination is inside the area).
Press the X in the top right corner of an avoided area to remove it. At
most 32 areas can be specified at the same time.
Removes of all avoided areas at once.
Displays the map legend, showing the meaning of symbols, lines and
colours on the map currently being shown.