TomTom RIDER 매뉴얼 - 페이지 8

{카테고리_이름} TomTom RIDER에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. TomTom RIDER 44 페이지. How to pair 2nd edition to a schuberth src communication system
TomTom RIDER에 대해서도 마찬가지입니다: 설치 매뉴얼 (1 페이지), 매뉴얼 (4 페이지)

페이지 인쇄

Lisbon.book Page 11 Thursday, March 1, 2007 8:39 AM

Cardo scala-rider™ headset

A Microphone

B On/Off button

C Speaker

D LED

E Volume down

F Volume up

G Charging connector

Before you can use your Bluetooth headset,

fully charge the headset using the charger

supplied with the headset.

Using your TomTom RIDER

Note: Make sure you use the correct charger. There

are different chargers for your TomTom RIDER and

your headset. Using the wrong charger may damage

the device.

Fully charging the headset takes between 2

and 3 hours. When charging, the LED is a

steady red. When charging is finished, the LED

turns off.

When the batteries are running low, an alert

tone is played.

Using your headset

To turn the headset on, press and hold the on/

off button for 6 seconds, until the LED flashes

blue 3 times. An ascending alert tone is

played. When the headset is on, the LED

flashes blue every 3 seconds.

To turn the headset off, press and hold the on/

off button for 3 seconds, until the LED flashes

red 3 times. A descending alert tone is played.

If you did not establish a Bluetooth connection

between your Bluetooth headset module and

your TomTom RIDER when you first turned

your RIDER on, you can establish the

connection at any time.

From the Main Menu, tap Change

Preferences. Tap Connect to headset and

follow the instructions to establish the

connection.