TomTom 4CS03 매뉴얼 - 페이지 6

{카테고리_이름} TomTom 4CS03에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. TomTom 4CS03 32 페이지.
TomTom 4CS03에 대해서도 마찬가지입니다: 사용자 설명서 (36 페이지)

Siena-USA-UG-NONLIVE.book Page 7 Thursday, June 24, 2010 2:32 PM

Switching on and off

Getting

started

Install your TomTom GO navigation device

in your car following the instructions in the

installation section at the start of this book.

To switch on your navigation device, press

and hold the On/Off button until you see the

start-up screen. The first time you switch on

your device, it may take a short time to start.

Setting up

When you first switch on your device, you

have to answer a few questions to set up the

device. Answer the questions by tapping

the screen.

You are asked whether you make regular

trips to the same locations. If you tap YES,

you can enter these destinations as your

favourite destinations. Every time you

switch on your device, you can immediately

select one of these locations as your desti-

nation.

To change these destinations or select a

new destination, tap Start-up preferences in

the Preferences menu, then select Ask for a

destination.

Getting started

Device not starting

In rare cases, your TomTom GO navigation

device may not start correctly or may stop

responding to your taps.

First, check that the battery is properly

charged. To charge the battery, connect

your device to the car charger. It can take up

to 2 hours to fully charge the battery.

If this does not solve the problem, you can

reset the device. To do this, press and hold

the On/Off button for 15 seconds and

release the button when your device begins

to restart.