TomTom GO 매뉴얼 - 페이지 8

{카테고리_이름} TomTom GO에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. TomTom GO 29 페이지. 5” gps with built-in bluetooth
TomTom GO에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지), 브로셔 및 사양 (7 페이지), 사용자 설명서 (36 페이지), 빠른 시작 매뉴얼 (22 페이지), 빠른 시작 매뉴얼 (16 페이지), 빠른 시작 매뉴얼 (40 페이지), 빠른 시작 매뉴얼 (21 페이지), 알아보기 (5 페이지)

Ravenna-UG.book Page 9 Wednesday, August 20, 2008 1:26 PM

Switching on and off

Before you

start

Install your TomTom GO in your car following

the instructions on the installation poster at

the start of this book.

To switch on your TomTom GO, press and

hold the On/Off button until you see the start-

up screen. The first time you switch on your

device, it may take a short while to start.

You have to answer a few questions to set up

your device.

Having problems?

In rare cases, your TomTom GO may not start

correctly or may stop responding to your taps.

First, check that the battery is properly

charged. To charge the battery, connect your

device to the TomTom Home charger, the

TomTom Car charger or to your computer. It

can take up to 2 hours to fully charge the

battery.

If this does not solve the problem, you can

reset the device. To do this, press and hold the

On/Off button for fifteen seconds and release

the button when your GO begins to restart.

Before you start

Battery notes

The battery in your TomTom GO charges

when you connect it to the car charger or to

your computer.

The light next to the On/Off button is orange

while the battery is charging and is green

when the battery is fully charged.

When you connect your GO to a computer

using the home dock, you are asked if you

want to connect to the computer. If you select

No and do not tap the screen within three

minutes, the device will automatically switch

off. This happens so that the battery can

charge faster.

Important: You should plug the USB

connector directly into a USB port on your

computer and not into a USB hub or USB port

on a keyboard or monitor.