TomTom LINK 530 설치 매뉴얼 - 페이지 17

{카테고리_이름} TomTom LINK 530에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. TomTom LINK 530 40 페이지.

Connecting to power

Connect the LINK 530 to the vehicle power supply with the standard vehicle voltage (12 V/24 V).

Do not connect to a voltage converter. The three wires GND, IGN and PWR+ (supply voltage)

must be connected.

Important: Follow the order of connecting the wires as described below. First connect the wires

then insert the plug into the LINK 530.

If you have inserted the plug into the LINK 530 first, you must connect the GND wire before you

connect the PWR+ wire and the IGN wire as described below.

1. Connect the GND wire (brown) to ground (clamp 31).

2. Connect the PWR+ wire (red) to the carry current (clamp 30).

The connection must be fused with max. 10A. If not, fuse the the PWR+ wire with one 2A fast

blow fuse.

3. Connect the IGN wire (black) to ignition (clamp 15).

The connection must be fused with max. 10A. If not, fuse the the IGN wire with one 2A fast

blow fuse.

4. Insert the 3-pin plug into the power cable connector.

If you need to disconnect the wires while the 3-pin plug is plugged in the LINK 530 make sure you

disconnect the GND wire last.