Epson LQ-570+ 설정 매뉴얼 - 페이지 5

{카테고리_이름} Epson LQ-570+에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson LQ-570+ 14 페이지. Sdx acd manager 5.2 printer setup
Epson LQ-570+에 대해서도 마찬가지입니다: 제품 지원 게시판 (20 페이지), 제품 지원 게시판 (5 페이지), 제품 정보 매뉴얼 (8 페이지), 설치 매뉴얼 (1 페이지), 매뉴얼 (12 페이지), 사양 (2 페이지), 매뉴얼 (8 페이지), 제품 지원 게시판 (16 페이지), 서비스 매뉴얼 (49 페이지)

Epson LQ-570+ Printer Operation

Installing the Ribbon Cartridge

Printer Setup Manual

SDX ACD Manager 5.2

Before installing the ribbon cartridge, make sure that the power cord is not plugged

into an electrical outlet.

1. Raise the paper-guide cover and rest it on the printer cover. Lift the paper guide

up and off. Lift the printer cover up and off. Grasp both ends of the clear plastic

paper-tension unit; lift up the front of the unit and then lift it off.

Warning: Never move the print head whilst the printer is turned on; this can

damage the printer. Also, if you just used the printer, the print head may be hot. Let

it cool for a few minutes before touching it.

2. Slide the print head to the middle of the printer.

3. Turn the ribbon-tightening knob in the direction of the arrow. This removes any

slack in the ribbon and makes it easier to install. Next, hold the ribbon cartridge

by its handle and push it firmly down into position; then press on both ends of

the cartridge to make sure the plastic hooks fit into the slots.

4. Use a pointed object, such as a ball point pen, to guide the ribbon between the

print head and ribbon guide. Turn the ribbon-tightening knob to help feed the

ribbon into place.

Installing the Ribbon Cartridge

Epson LQ-570+ Printer Operation - Page 5

38DHB0002UKBP - Issue 1 (March 1999)