Epson LQ-570+ 설정 매뉴얼 - 페이지 8

{카테고리_이름} Epson LQ-570+에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson LQ-570+ 14 페이지. Sdx acd manager 5.2 printer setup
Epson LQ-570+에 대해서도 마찬가지입니다: 제품 지원 게시판 (20 페이지), 제품 지원 게시판 (5 페이지), 제품 정보 매뉴얼 (8 페이지), 설치 매뉴얼 (1 페이지), 매뉴얼 (12 페이지), 사양 (2 페이지), 매뉴얼 (8 페이지), 제품 지원 게시판 (16 페이지), 서비스 매뉴얼 (49 페이지)

Epson LQ-570+ Printer Operation

Loading Continuous Paper with the Pull Tractor

Printer Setup Manual

SDX ACD Manager 5.2

By placing the tractor in the pull-tractor position, you can load paper from the rear,

front, or bottom. The steps are the same for all paper paths.

Note: When the tractor is in the pull-tractor position, do not use the TEAR-OFF

button or the LOAD/EJECT button to feed the paper back to the standby position.

1. Make sure the printer is turned off and the paper guide and the printer cover are

removed.

2. Make sure the tractor is in the pull-tractor position and the paper-release lever is

in the pull-tractor position.

3. Release the tractor's sprocket units by pulling the sprocket lock levers forward.

4. Slide the left sprocket unit to approximately 12 mm (l/2 inch) from the far left

position and push the sprocket lock lever back to lock the sprocket unit in place.

Then slide the right sprocket unit to match the width of your paper, but do not

lock it in place. Move the paper support so it is midway between the sprocket

units.

5. If you are inserting paper in the front paper slot, remove the front cover and

slide the edge guide completely to the left.

Loading Continuous Paper with the Pull Tractor

Epson LQ-570+ Printer Operation - Page 8

38DHB0002UKBP - Issue 1 (March 1999)