Epson LQ-570e 제품 정보 매뉴얼 - 페이지 11

{카테고리_이름} Epson LQ-570e에 대한 제품 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson LQ-570e 18 페이지. Epson serial impact dot matrix printers
Epson LQ-570e에 대해서도 마찬가지입니다: 제품 정보 매뉴얼 (8 페이지), 매뉴얼 (12 페이지), 빠른 참조 매뉴얼 (15 페이지), 사양 (2 페이지), 조립 설명서 (8 페이지), 제품 지원 게시판 (16 페이지), 참조 매뉴얼 (34 페이지)

페이지 인쇄

To avoid peeling labels off the backing sheet and jamming the

printer, follow these steps when you remove continuous paper

with labels from the printer:

1. After you finish printing, tear off the fresh supply of

continuous labels at the perforation nearest the paper

entry slot.

2. Hold down the

button to eject the remaining labels

from the printer.

When using the push tractor, load continuous paper in the rear

slot. For information on when to use the push tractor, see

"Available Paper Paths" on page 8. For instructions on loading

paper on the push tractor and removing a printed document,

see the User's Guide.

To remove the tractor from the push position, follow these

steps:

1. Remove any paper from the tractor.

2. Turn off the printer.

3. Remove the paper guide by holding both edges and lifting

it up.

4. Press the tractor's lock tabs, tilt the tractor up, and lift it out

of the printer.

If a tractor is installed in the pull position, you need to remove

it and install the paper tension unit (as described under

"Removing the pull tractor" on page 12) before using the push

tractor.

To reinstall the tractor in the push position, follow these steps:

1. Make sure the printer is turned off.

2. Remove the paper guide by holding both edges and lifting it

up.

3. Lower the tractor into the mounting slots ( ), and press

down both ends ( ) of the tractor to make sure that it is

firmly seated.

You are now ready to load continuous paper onto the push

tractor. If you need instructions, see the User's Guide.

4/00

EPSON LQ-570e

- 11