Epson P6000 - Multimedia Photo Viewer 제품 지원 게시판 - 페이지 17
{카테고리_이름} Epson P6000 - Multimedia Photo Viewer에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson P6000 - Multimedia Photo Viewer 28 페이지. Surecolor p-series
Epson P6000 - Multimedia Photo Viewer에 대해서도 마찬가지입니다: 제품 지원 게시판 (17 페이지), 브로셔 및 사양 (6 페이지), 기본 작동 매뉴얼 (29 페이지), 사용 설명서 (46 페이지), 지침 (2 페이지)
페이지 인쇄
IMPORTANT: If you update to firmware Ver 1.57 temporarily before updating to 2.40,
PLEASE DO NOT TURN OFF THE UNIT DURING THE IPL UPDATE. If it is interrupted,
DAMAGE to the Viewer's MAIN BOARD may occur and the unit will need to be repaired.
If the firmware 2.40 update failed, or if the viewer was inadvertently turned off during firmware
update (except IPL update on Ver1.57 as mentioned above), please perform following steps:
1. Remove the "PSV50240.FNC" file from the PSV5FIRM folder on the memory card that
is used in this update.
2. Insert memory card into viewer.
3. Turn on viewer with RATE (★) + DISPLAY pressed.
4. "Main F/W Update" message is displayed, and release key when you see the memory
card access LED blink.
5. It takes about 4 minutes, then "Please turn off" message is displayed. The viewer will be
turned off automatically.
6. Turn it on again, and if you see the HOME screen, recover has completed. There is no
need for any further updates.
If the update does not start, please check following and do the update again:
1. Check to see if the SD / CF memory card is defective or not.
2. Check whether the CF card capacity is 16GB or larger.
3. Check "PSV5FIRM" folder existence in memory card root folder.
Please check following if you see the different message:
1. Check whether the AC adapter is connected, and AC power is correctly supplied.
2. Check battery insertion.
3. Check whether the SD card is formatted by the SD supporting device.
4. Check whether the folder "PSV5FIRM" folder has "PSV50240.FNC" file.
5. Check whether the "PSV50240.FNC" has 8,000 KB in size.
Check following if the updated version is different:
1. If the version is displayed as "02.40.0179-0108-0107-0121", then the 2.40 update was
executed on a viewer that had a firmware prior to the Ver 1.57 firmware update.
2. Please perform to firmware update on Ver 1.57, and re-perform to Ver2.40 firmware
update again.
3. If the version is displayed "02.40.0179-0108-0200-0121", or 02.40.0179-0110-0107-
0121", please update the Ver 1.57 firmware again, then perform Ver 2.40 again.
Page 6 of 6
PSB.2009.11.001