Epson P7000 - Multimedia Photo Viewer 제품 지원 게시판 - 페이지 9
{카테고리_이름} Epson P7000 - Multimedia Photo Viewer에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson P7000 - Multimedia Photo Viewer 17 페이지. Surecolor p-series
Epson P7000 - Multimedia Photo Viewer에 대해서도 마찬가지입니다: 브로셔 및 사양 (6 페이지), 제품 지원 게시판 (28 페이지), 기본 작동 매뉴얼 (29 페이지), 사용 설명서 (46 페이지), 지침 (2 페이지)
페이지 인쇄
Steps:
1. Install a blank memory card into a memory card reader/writer and copy the
"PSV5FIRM" folder (including all the files in the folder) to the root directory of the
memory card.
2. Verify that the battery is installed in the P-6000 or P-7000 viewer.
3. Connect the AC adapter to the viewer, but do not power it on.
4. After the firmware file has been copied to the memory card, insert the CompactFlash or
SD memory card into the viewer.
5. Press and hold down the "OK" and
shown below.
Warning:
Do not turn off the viewer or attempt to remove the battery or disconnect the
AC adapter at any time during the firmware update.
When you see the EPSON logo name, release the OK and
update will begin and take approximately 3.5 minutes to complete. The SubCPU
firmware update starts next and takes about 3.5 minutes to complete. During the
SubCPU firmware update, the blue activity LED will temporarily stop blinking; this is
normal. Once the firmware update is completed you should see this screen.
keys while sliding the "POWER" switch as
Page 3 of 4
PSB.2009.09.002
keys; the main firmware