Acuity Brands Lighting Lithonia Lighting TWP-LED Series 설치 지침 - 페이지 4
{카테고리_이름} Acuity Brands Lighting Lithonia Lighting TWP-LED Series에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Acuity Brands Lighting Lithonia Lighting TWP-LED Series 4 페이지.
페이지 인쇄Installation Instructions
TWP-LED
Wire Guard
WALL MOUNT:
1. Drill wall in two places for two
(2) 10-24 fasteners (not provided)
per drilling detail (Figure D).
2. Place wire guard over fixture.
3. Secure in place with fasteners
from step 1.
FIXTURE MOUNT:
1. Drill fixture per drilling de-
tail (Figure E). NOTE: Remove
photoelectric cell (when provided)
before drilling for fixture mounted
wire guard.
2. Place wire guard over fixture.
3. Secure in place with two (2) 10-
24 fasteners, washers, and spacers
(provided) as shown (Figure F).
Troubleshooting: If this fixture fails to operate properly, check to make sure: • The fixture is wired correctly.
grounded correctly.
• The line voltage at the fixture is correct. If all these variables have been checked and the fixture still
does not operate as specified, contact your local Lithonia Lighting distributor.
TWP Back Housing
1-1/2"
18-1/2"
1"from
wall
7 1/2"
Figure D
Drill two places
for 10-24 fasteners
(by others)
Figure E
Figure F
• The fixture is