Crow EDS-2000 설치 지침 및 사용자 설명서 - 페이지 8
{카테고리_이름} Crow EDS-2000에 대한 설치 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Crow EDS-2000 20 페이지. Outdoor pir + mw detector
Crow EDS-2000에 대해서도 마찬가지입니다: 설치 지침 및 사용자 설명서 (20 페이지)
페이지 인쇄
5
Selecting mounting location
The installation of the EDS-2000 requires straight and solid base for the detector and setting of
front panel against the center of protected area.
The protected area must be free from obstacles like walls, fences, trees, ditches and other
microwave detectors, as well as systems of anti-intrusion surveillance.
The bracket provides EDS-2000 installation on a wall. The wall should be leveled.
Choose a location most likely to intercept an intruder according to detection pattern on page 8.
Avoid the following Installation Locations:
• Facing direct sunlight.
• Facing areas subject to rapid temperature changes.
• Wall angle of more than 10º from perpendicular line.
• Mounting at more than 10º Deviation from horizontal line.
• Facing metal doors.
• Do not install near direct source of heat or air gust.
• Clear all physical obstacles from the detection area
(e.g. Plants, laundries, etc.)
• Clear all light reflecting surfaces from the detection area,
as well as water puddles.
• Avoid installation on the following types of ground:
Thick vegetation, Grass (un-mown), Water, Sand and Metal.
NOTE:
Recommended installation height is 2.1m (6.9ft).
The PIR sensor detects motion crossing the beam; it is less sensitive detecting motion towards
the detector.
The EDS-2000 performs best when provided with a constant and stable environment.
In order to ensure suitable operation of the EDS-2000 type of ground should be one of the
following: Asphalt concrete, Cement, Soil, Clay, Gravel or Grass (mown).
8