Epson R800 - Stylus Photo Color Inkjet Printer 제품 정보 - 페이지 14
{카테고리_이름} Epson R800 - Stylus Photo Color Inkjet Printer에 대한 제품 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson R800 - Stylus Photo Color Inkjet Printer 17 페이지. Product support bulletin(s)
Epson R800 - Stylus Photo Color Inkjet Printer에 대해서도 마찬가지입니다: 여기에서 시작하기 매뉴얼 (6 페이지), 사용자 설명서 (12 페이지), 제품 지원 게시판 (6 페이지), 제품 지원 게시판 (1 페이지)
페이지 인쇄
Epson Stylus Photo R800
Removing and Installing Ink Cartridges
Be sure you have a new ink cartridge before you begin. Once
you start replacing a cartridge, you must complete all the steps
in one session.
You can replace a cartridge whether the red H ink light is off,
flashing, or on.
1. Make sure the printer is turned on (the green P power light
should be on, but not flashing). Then open the printer
cover.
2. Press the H ink button.
The print head moves and the green P power light flashes.
3. If the red H ink light is off, the print head moves to the
replacement position. Go to step 5.
If the red H ink light is flashing or on (indicated a low or
empty cartridge), the print head moves to the _ position on
the printer. The cartridge directly beneath the _ mark
needs to be replaced. Make a note of which cartridge it is.
4. Press the H button again. If another cartridge is low or
empty, the print head moves it to the _ mark again. Make a
note of this cartridge too and repeat this step.
If no other cartridges are low or empty, the print head
moves to the replacement position when you press the
H button.
5. Lift up the cartridge cover.
Epson Stylus Photo R800
14 -
6. Press in the tab on the back of the cartridge, lift it out of the
printer, and dispose of it carefully.
7. Shake the new cartridge four or five times before opening its
package. (Don't shake it after it's unwrapped.)
8. Remove the new cartridge from its package.
Caution: Don't touch the green circuit board on the front of the
cartridge; you may inhibit normal operation and printing.
9. Slide the new cartridge into its slot. The side with the green
circuit board goes in the front of the slot.
10. Press the cartridge down until it clicks into place.
11. If you need to replace any other ink cartridges, repeat
steps 6 through 10 before continuing with step 12.
12. Close the cartridge cover, then close the printer cover.
1/04