Epson RX620 - Stylus Photo Color Inkjet 제품 정보 매뉴얼 - 페이지 17
{카테고리_이름} Epson RX620 - Stylus Photo Color Inkjet에 대한 제품 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson RX620 - Stylus Photo Color Inkjet 19 페이지. Epson scan icm updater v1.20 (psb.2008.07.001)
Epson RX620 - Stylus Photo Color Inkjet에 대해서도 마찬가지입니다: 사양 (2 페이지), 여기에서 시작하기 매뉴얼 (8 페이지), 업데이트 (1 페이지), 기본 작동 매뉴얼 (45 페이지), 사용 설명서 (4 페이지)
페이지 인쇄
Epson Stylus Photo RX620
3. Open the ink cartridge holder's cover.
Caution:
Never attempt to open the cartridge holder's cover while the
print head is moving. Wait until the cartridges have moved to the
replacement position.
4. Remove the cartridge you need to replace. Press in the tab at
the back of the cartridge to release it, then lift the cartridge
straight out. Dispose of it carefully.
Note:
The illustration above shows the black cartridge being removed.
Only remove the cartridge(s) you need to replace.
5. Unwrap the new cartridge.
6. Insert the new cartridge into the holder. Press down firmly
until it clicks into place.
If you need to replace other ink cartridges, repeat steps 4
through 6 before continuing with the next step.
Epson Stylus Photo RX620
16 -
7. Close the ink cartridge holder's cover, then close the scanner
section.
Caution:
If you find it difficult to close the cover, make sure all the
cartridges are firmly seated. Press down on each newly installed
cartridge until you hear it click into place. Do not attempt to force
the cover closed.
The RX620 begins charging the ink delivery system and the
message
Ink Charging
you see the message
, press
completed
Caution:
Never turn off the RX620 during ink charging, unless the RX620
hasn't moved or made noise for more than 5 minutes. This may
cause incomplete charging of ink.
Aligning the Print Head
If your printouts look grainy or vertical lines appear jagged,
you may need to align the print head.
1. Make sure the RX620 is turned on and not printing.
2. Load several sheets of plain letter-size paper.
3. Press the
Setup
u and d buttons to select
4. Press the
button, then press
OK
alignment pattern.
11/04
appears on the LCD screen. When
Ink cartridge replacement
.
OK
button to enter setup mode, then press the
Head Alignment
again to print an
OK
.