Crow FW2-SIREN2CP-8/9F 설치 매뉴얼 - 페이지 10

{카테고리_이름} Crow FW2-SIREN2CP-8/9F에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Crow FW2-SIREN2CP-8/9F 19 페이지. Siren system

- User Guide

Siren's Jumper's MODE SET-UP

Jumper No.

Learn the FW2 Siren with SERENITY

There are 3 options

Option 1:

Step 1: Insert the battery to the Siren while pressing learn button‐>The FW2‐Siren led

Step 2: Enter to the Installer mode P000000E‐> Enter P64 ʹLearn radio output'.

Step 3: Use the +, ‐ keys to Select the required learned output number

Step 4: Press the Enter key.

Step 5: Press on the learning button (Siren), the control‐panel will display the message

Step 6: To test functionality of the serenity after learning refer to ʺfunction testing

NOTE: During the learning process or the operation of the Siren is recommended to

Function if = O (Open)

Not in used for RUNNER 2 and

SERENITY control panels

NO Flashes with ARM/Disarm

NO Beeps with ARM/Disarm

2 Min Time out

Using Installer programming mode:

will blink for 30 sec ‐> the FW2‐Siren is now ready for use.

ʺCompleteʺ at the end of the learning process ‐>The Siren led will blink , for

3 sec to indicate that the FW2‐Siren was learned.

after FW2 Siren learningʺ page 10

keep a distance as two meters between the serenity C.P to the Siren.

Function if =1 (Close)

Flashes appear with ARM/Disarm

Arm: 2 Flashes (@LOW BAT 3+3

Flashes)

Disarm: 1 Flash (@LOW BAT 2

Flashes)

Beeps sound with ARM/Disarm

Arm: 2 Beeps(@LOW BAT 3+3

Beeps)

Disarm: 1 Beep (@LOW BAT 2

Beeps)

15 Min Time out